ANGPTL3/Angiopoietin-like 3 protein synthesis

Vupanorsen (AKCEA-ANGPTL3-L Rx ) is an N-acetyl galactosamine-conjugated antisense oligonucleotide targeted to the liver that selectively inhibits angiopoietin-like 3 (ANGPTL3) protein synthesis. [2]

Two hundred eighty-six subjects were randomized: 44 to placebo and 242 to vupanorsen. The median age was 64 (interquartile range, 58-69) years, 44% were female, the median non-HDL-C was 132.4 (interquartile range, 118.0-154.1) mg/dL, and the median triglycerides were 216.2 (interquartile range, 181.4-270.4) mg/dL. Vupanorsen resulted in significant decreases from baseline over placebo in non-HDL-C ranging from 22.0% in the 60 mg every 2 weeks arm to 27.7% in the 80 mg every 2 weeks arm (all P<0.001 for all doses). There were dose-dependent reductions in triglycerides that ranged from 41.3% to 56.8% (all P<0.001). The effects on LDL-C and ApoB were more modest (7.9%-16.0% and 6.0%-15.1%, respectively) and without a clear dose-response relationship' and only the higher reductions achieved statistical significance. ANGPTL3 levels were decreased in a dose-dependent manner by 69.9% to 95.2% (all P<0.001). There were no confirmed instances of significant decline in renal function or platelet count with vupanorsen. Injection site reactions and >3× elevations of alanine aminotransferase or aspartate aminotransferase were more common at higher total monthly doses (up to 33.3% and 44.4%, respectively), and there was a dose-dependent increase in hepatic fat fraction (up to 76%). Conclusions: Vupanorsen administered at monthly equivalent doses from 80 to 320 mg significantly reduced non-HDL-C and additional lipid parameters. Injection site reactions and liver enzyme elevations were more frequent at higher doses, and there was a dose-dependent increase in hepatic fat fraction. [1]

---

This was a double-blind, placebo-controlled, dose-ranging, Phase 2 study. Patients (N =105) with fasting triglycerides >150 mg/dL (>1.7 mmol/L), type 2 diabetes, and hepatic steatosis were treated for 6 months with 40 or 80 mg every 4 weeks (Q4W), or 20 mg every week (QW) of vupanorsen, or placebo given subcutaneously. The primary efficacy endpoint was per cent change in fasting triglycerides from baseline at 6 months. Median baseline triglycerides were 2.84 mmol/L (252 mg/dL). Significant reductions in triglycerides of 36%, 53%, 47%, and in ANGPTL3 of 41%, 59%, 56%, were observed in the 40 mg Q4W, 80 mg Q4W, and 20 mg QW groups, respectively, compared with 16% reduction in triglycerides and 8% increase in ANGPTL3 in placebo. Compared with placebo, vupanorsen 80 mg Q4W reduced apolipoprotein C-III (58%), remnant cholesterol (38%), total cholesterol (19%), non-high-density lipoprotein cholesterol (HDL-C; 18%), HDL-C (24%), and apolipoprotein B (9%). There was no improvement in glycaemic parameters, or hepatic fat fraction. Treatment with vupanorsen was not associated with clinically significant changes in platelet counts, and the most common adverse events were those at the injection site, which were generally mild. Conclusion: Vupanorsen results in a favourable lipid/lipoprotein profile and provides a potential strategy for residual cardiovascular risk reduction. [2]

Adults with non-high-density lipoprotein cholesterol (non-HDL-C) ≥100 mg/dL and triglycerides 150 to 500 mg/dL on statin therapy were randomized in a double-blind fashion to placebo or 1 of 7 vupanorsen dose regimens (80, 120, or 160 mg SC every 4 weeks, or 60, 80, 120, or 160 mg SC every 2 weeks). The primary end point was placebo-adjusted percentage change from baseline in non-HDL-C at 24 weeks. Secondary end points included placebo-adjusted percentage changes from baseline in triglycerides, low-density lipoprotein cholesterol (LDL-C), apolipoprotein B (ApoB), and ANGPTL3.[1]

[1]. Effect of Vupanorsen on Non-High-Density Lipoprotein Cholesterol Levels in Statin-Treated Patients With Elevated Cholesterol: TRANSLATE-TIMI 70. Circulation. 2022;145(18):1377-1386.

[2]. Vupanorsen, an N-acetyl galactosamine-conjugated antisense drug to ANGPTL3 mRNA, lowers triglycerides and atherogenic lipoproteins in patients with diabetes, hepatic steatosis, and hypertriglyceridaemia. Eur Heart J. 2020;41(40):3936-3945.

2097587-62-5

Vupanorsen sodium;2172852-12-7

White to off-white solid powder

ISIS-703802; IONIS ANGPT-L3Rx; ISIS 703802

2934.99.9001

Powder      -20°C    3 years

                     4°C     2 years

In solvent   -80°C    6 months

                  -20°C    1 month

Note: Please store this product in a sealed and protected environment, avoid exposure to moisture.

Room temperature (This product is stable at ambient temperature for a few days during ordinary shipping and time spent in Customs)

May dissolve in DMSO (in most cases), if not, try other solvents such as H2O, Ethanol, or DMF with a minute amount of products to avoid loss of samples

Note: Listed below are some common formulations that may be used to formulate products with low water solubility (e.g. < 1 mg/mL), you may test these formulations using a minute amount of products to avoid loss of samples.

---

Injection Formulation 1: DMSO : Tween 80： Saline = 10 : 5 : 85 (i.e. 100 μL DMSO stock solution → 50 μL Tween 80 → 850 μL Saline)
*Preparation of saline: Dissolve 0.9 g of sodium chloride in 100 mL ddH ₂ O to obtain a clear solution.
Injection Formulation 2: DMSO : PEG300 ：Tween 80 : Saline = 10 : 40 : 5 : 45 (i.e. 100 μL DMSO → 400 μLPEG300 → 50 μL Tween 80 → 450 μL Saline)
Injection Formulation 3: DMSO : Corn oil = 10 : 90 (i.e. 100 μL DMSO → 900 μL Corn oil)
Example: Take the Injection Formulation 3 (DMSO : Corn oil = 10 : 90) as an example, if 1 mL of 2.5 mg/mL working solution is to be prepared, you can take 100 μL 25 mg/mL DMSO stock solution and add to 900 μL corn oil, mix well to obtain a clear or suspension solution (2.5 mg/mL, ready for use in animals).

View More

Injection Formulation 4: DMSO : 20% SBE-β-CD in saline = 10 : 90 [i.e. 100 μL DMSO → 900 μL (20% SBE-β-CD in saline)]
*Preparation of 20% SBE-β-CD in Saline (4°C，1 week): Dissolve 2 g SBE-β-CD in 10 mL saline to obtain a clear solution.
Injection Formulation 5: 2-Hydroxypropyl-β-cyclodextrin : Saline = 50 : 50 (i.e. 500 μL 2-Hydroxypropyl-β-cyclodextrin → 500 μL Saline)
Injection Formulation 6: DMSO : PEG300 : castor oil : Saline = 5 : 10 : 20 : 65 (i.e. 50 μL DMSO → 100 μLPEG300 → 200 μL castor oil → 650 μL Saline)
Injection Formulation 7: Ethanol : Cremophor : Saline = 10： 10 : 80 (i.e. 100 μL Ethanol → 100 μL Cremophor → 800 μL Saline)
Injection Formulation 8: Dissolve in Cremophor/Ethanol (50 : 50), then diluted by Saline
Injection Formulation 9: EtOH : Corn oil = 10 : 90 (i.e. 100 μL EtOH → 900 μL Corn oil)
Injection Formulation 10: EtOH : PEG300：Tween 80 : Saline = 10 : 40 : 5 : 45 (i.e. 100 μL EtOH → 400 μLPEG300 → 50 μL Tween 80 → 450 μL Saline)

---

Oral Formulation 1: Suspend in 0.5% CMC Na (carboxymethylcellulose sodium)
Oral Formulation 2: Suspend in 0.5% Carboxymethyl cellulose
Example: Take the Oral Formulation 1 (Suspend in 0.5% CMC Na) as an example, if 100 mL of 2.5 mg/mL working solution is to be prepared, you can first prepare 0.5% CMC Na solution by measuring 0.5 g CMC Na and dissolve it in 100 mL ddH2O to obtain a clear solution; then add 250 mg of the product to 100 mL 0.5% CMC Na solution, to make the suspension solution (2.5 mg/mL, ready for use in animals).

View More

Oral Formulation 3: Dissolved in PEG400
Oral Formulation 4: Suspend in 0.2% Carboxymethyl cellulose
Oral Formulation 5: Dissolve in 0.25% Tween 80 and 0.5% Carboxymethyl cellulose
Oral Formulation 6: Mixing with food powders

---

Note: Please be aware that the above formulations are for reference only. InvivoChem strongly recommends customers to read literature methods/protocols carefully before determining which formulation you should use for in vivo studies, as different compounds have different solubility properties and have to be formulated differently.

---

 (Please use freshly prepared in vivo formulations for optimal results.)